INCH-POUND
MIL-DTL-11733E
3 December 2001
SUPERSEDING
MIL-C-11733D
11 April 1974
DETAIL SPECIFICATION
CYLINDER, COMPRESSED GAS: AMMONIA,
WITH VALVE (DOT 4AA480)
This specification is approved for use by all departments and agencies of the Department
of Defense.
1. SCOPE
1.1 Scope. This specification covers two types of steel cylinders, with valve and cap,
intended for anhydrous ammonia service.
1.2 Classification. The cylinders covered by this specification will be of the following
types, as specified (see 6.2).
Type I - 100 pounds
Type II - 150 pounds
2. APPLICABLE DOCUMENTS
2.1 General. The documents listed in this section are specified in sections 3 and 4 of this
specification. This section does not include documents cited in other sections of this specification
or recommended for additional information or as examples. While every effort has been made to
ensure the completeness of this list, document users are cautioned that they must meet all specified
requirements of the documents cited in sections 3 and 4 of this specification, whether or not they
are listed.
Beneficial comments (recommendations, additions, deletions) and any pertinent data that may be
of use in improving this document should be addressed to: Defense Supply Center Richmond,
ATTN: DSCR-VBD, Richmond, VA 23297-5610 by using the Standardization Document
Improvement Proposal (DD Form 1426) appearing at the end of this document or by letter.
AMSC N/A
FSC 8120
DISTRIBUTION STATEMENT A. Approved for public release; distribution is unlimited.
For Parts Inquires submit RFQ to Parts Hangar, Inc.
© Copyright 2015 Integrated Publishing, Inc.
A Service Disabled Veteran Owned Small Business