MIL-DTL-11733E
DRAWINGS
810-1385867
- Decalcomania for Navy Gas Cylinders.
(Copies of drawings required by suppliers in connection with a specific procurement
function should be obtained from the procuring activity or as directed by the contracting officer.)
2.3 Non-government publications. The following documents form a part of this
document to the extent specified herein. Unless otherwise specified, the issues of documents
that are DoD adopted are those listed in the issue of the DoDISS cited in the solicitation. Unless
otherwise specified, the issues of the documents not listed in the DoDISS are the issues of
documents cited in the solicitation (see 6.2).
STEEL STRUCTURES PAINTING COUNCIL (SSPC)
SSPC-SP5
-
White Metal Blast Cleaning (DoD adopted).
SSPC-SP6
-
Commercial Blast Cleaning (DoD adopted).
SSPC-SP10
-
Near-White Blast Cleaning (DoD adopted).
SSPC-Paint 25
-
Zinc Oxide, Alkyd, Linseed Oil Primer for Use Over Hand
Cleaned Steel, Type I and Type II.
(Application for copies should be addressed to the Steel Structures Painting Council,
4400 Fifth Avenue, Pittsburgh, PA 15213. Electronic copies of SSPC documents may be
obtained from https://www.sspc.org/.)
MASTER PAINTERS INSTITUTE (MPI)
MPI Reference 9
- Enamel, Alkyd, Gloss, Low VOC Content.
(Application for copies should be addressed to the Painting & Decorating Contractors of
America - National Office (PDCA), 3913 Old Lee Highway, suite 33-B, Fairfax, VA 22030-
2433.)
2.4 Order of precedence. In the event of a conflict between the text of this document and
the references cited herein, the text of this document takes precedence. Nothing in this document,
however, supersedes applicable laws and regulations unless a specific exemption has been obtained.
3. REQUIREMENTS
3.1 Configuration. Cylinders shall conform to requirements of 49 CFR 178.56 for a
Department of Transportation (DOT) 4AA480 cylinder. The cylinders shall be within dimensions
specified in table I, in accordance with figure 1, and shall be as specified herein. All dimensions in
table I are in inches. The tolerance for diameter (D) is plus or minus 1/2 inch and the tolerance for
height (H) is plus or minus 1 inch.
3
For Parts Inquires submit RFQ to Parts Hangar, Inc.
© Copyright 2015 Integrated Publishing, Inc.
A Service Disabled Veteran Owned Small Business