INCH-POUND
MIL-DTL-17376/3B
8 MAY 2012
SUPERSEDING
MIL-C-17376/3A
22 MARCH 2007
DETAIL SPECIFICATION SHEET
CAPS AND FLANGES COMPRESSED-GAS CYLINDER:
FLANGES, HIGH PRESSURE
Reactivated after 22 March 2007 and may be used for new and
existing designs and acquisitions.
This detail specification sheet is approved for use by all
departments and agencies of the Department of Defense.
The requirements for acquiring the product described herein shall consist of this detail
specification sheet and MIL-DTL-17376.
INTENDED USE:
1. The flanges covered by this specification sheet are intended to provide anchorage on
the shoulders of high pressure cylinders for cylinder caps to provide protection for the cylinder
valve against damage in storage, handling, and shipping.
REQUIREMENTS:
1. Flange: The compressed-gas cylinder high pressure flange shall be as specified herein
and in accordance with figure 1. Figure 1 is a representative neck ring and may be varied
provided dimensions of threaded portions are as shown and the dimensions fit the configuration
of the cylinder.
2. Material. The steel used shall have a carbon content not greater than 0.25 percent or
shall be composition G41000 of SAE J402, "(R) New Steel Designation System for Wrought or
Rolled Steel".
AMSC N/A
FSC 8120
For Parts Inquires submit RFQ to Parts Hangar, Inc.
© Copyright 2015 Integrated Publishing, Inc.
A Service Disabled Veteran Owned Small Business